Lavor EG-MS 3800 Mode D'emploi page 12

i) In order to prevent accidents or injuries,
mind the weight of the appliance when
DE
choosing the storage location (see
technical data).
5. Service
a) Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool
is maintained.
6. Other risks
a) DANGER: Danger of explosion. Do not
pump corrosive, highly combustible or
explosive fluids (e.g. petroleum, petrol,
acids or nitro thinner).
b) DANGER: Danger of explosion.Do not
operate the device in fire or explosion-
endangered surroundings.
c) DANGER: Water that has been delivered
with this appliance is no drinking water!
d) DANGER: This can cause damage to the
appliance.
e) DANGER: Do not pump greases, oils and
salt water.
f) DANGER: Do not pump waste water
from sanitary facilities and silty water
with a lower flowability than clear water.
g) DANGER: Do not pump water that has a
higher temperature than 35°C.
h) Injury hazard! Do not use the appliance
unattended if there is the risk of fouling.
When using the pump, always observe
the following safety instructions.
Before use check the pump for damage.
n
Should the pump be damaged, it must
not be used.
Only connect the pump to an electric
n
group which is protected with an earth
leakage switch (30 mA).
Do not use the pump in swimming pools
n
or other places where persons could find
themselves in the vicinity of the pump in
the water.
Do not use the pump in fish ponds or
n
fountains.
Never use the pump if no outlet pipe of
n
min. 20 cm has been fitted.
12
Never let the pump run dry.
n
Always remove the mains plug from the
n
wall socket before moving or servicing
the pump.
If the mains cable is damaged, it has to
n
be replaced by the manufacturer, its
after sales service or a similarly qualified
person, in order to avoid a danger.
Never pull an attached water hose to
n
move the machine.
If the tank leaks, switch off the machine
n
immediately. Have the machine repaired
by an authorised technician.
Make sure that the machine is switched
n
off and unplugged and that the tank is
pressure free before troubleshooting or
servicing, or when the machine is not
used.
The moist collected in the tank must be
n
drained. Not bleeding the tank can lead
to leakage and may cause a dangerous
situation.
The following symbols are used
throughout this manual:
•
Denotes risk of personal injury or
damage to the machine.
PROPER USE
Your water pump has been designed to
pump clean water. The machine is
not suitable for pumping salt water.
The maximum water temperature is 35 °C.
The pump is not intended for continuous
use.
This appliance has been designed for use in
private households and is not intended for
commercial use.
The manufacturer is not responsible for
any damages that may occur on account of
improper use or wrong operations.
DESCRIPTION (FIG. A)
1 On/off switch
2 Mounting holes
3 Pump housing
4 Drain hose connection