Avanti FFFDS175L3S Manuel D'instructions page 9

Refrigerator Temperature Control
•
CONTROL PANEL – CHILD LOCK
The CONTROL PANEL LOCK is designed to prevent any changes to the settings to the refrigerator.
To enable the CHILD LOCK, press the LOCK button, the CHILD LOCK icon will turn on. The
control panel will be locked until unlocked at the control panel or there is a loss of power.
To disable the CHILD LOCK, press and hold the lock button for approximately 3 seconds until
the LOCK icon turns off and the control panel is working in normal operation mode.
•
CONTROL PANEL – STANDBY
The CONTROL PANEL will go dark after approximately 5 minutes of no activity
To reactive the display, simply press any of the buttons on the control panel.
Setting the Temperature Control
•
Your unit has one control for regulating the temperature. The temperature control is located on the
outside of the refrigerator compartment door.
•
The first time you turn the unit on, the unit will start at the default temperature set at the factory,
41ºF in the refrigerator section and -04ºF in the freezer section.
•
The first time you turn the unit on, adjust the temperature in the refrigerator compartment to 36ºF
and run for at least 4 hours before placing foods inside. This will ensure the freezer cabinet is thoroughly
chilled and the refrigerator compartment will be stabilized before food is placed. Then adjust the
temperature setting to your desired setting that best suits your needs.
To adjust the temperature in each zone, press the appropriate zone button, the selected zone will flash on and off. The
temperature will change according to the pre-set temperatures as shown below, you will hear a bell chime with each
press of the control panel buttons.
OPERATING YOUR APPLIANCE
9