PROZIS ANKOR Manuel D'utilisation page 4

EN
• If battery acid leaks, avoid contact with the skin, eyes and mucous membranes. In case of
contact with the acid, immediately rinse the affected area with plenty of clean water and
seek
• medical assistance immediately.
• Remove the batteries from the product if you do not intend to use the product for a longer
period of time, or if the battery runs out of power. Batteries can leak and damage the
product.
CAUTION! This symbol highlights dangerous situations that can lead to minor to
moderate injuries, damage, malfunction, and/or destruction of the device.
To prevent harm or damage from happening to users or others, make sure to comply
with the following requirements.
Protect the device against:
• Damage and water splashes.
• Heat, direct sunlight, and open flames.
• Impacts and similar violent effects.
• Do not use any astringent or abrasive cleaning agents.
• To avoid any risk, do not make any modifications to the device.
• Do not immerse the product in water or other liquids!
User manual
PACKAGE CONTENTS
1 × Prozis Ankor - Smartphone hand grip & wireless shutter control
1 × CR2016 Battery
1 × Quick Guide
PRODUCT OVERVIEW (SEE PAGE 2)
1. Photo key
2. Remote control indicator light
3. Mobile phone clip
4. Handle
5. 1⁄4 Standard screw thread
MAINTENANCE AND CLEANING
Cleaning:
• Switch off the appliance, detach it from the smartphone, and remove the battery before
cleaning.
• Do not use aggressive or abrasive cleaning agents or materials when cleaning, such as
scouring milk or steel wool. These can damage the top surface of the device!
6
• Protect the appliance from water drops and water spray.
• Only use a clean, dry cloth to clean the product and never use any corrosive liquids. Use a
slightly damp cloth and a mild cleaning agent to remove any stubborn dirt.
• Make sure moisture does not enter the product while cleaning to prevent damage to the
product and related repairs.
STORAGE:
• When no longer using the device, store it in a dry location, protected from dust and direct
sunlight.
• Remove the battery if the device is not to be used for an extended period of time.
• Store your product inside its original packaging.
INSTRUCTIONS:
B C
E F
Tripod not included
How to use
BT PAIRING: see figure B
Press the Photo key for 3 seconds to enter the BT pairing status. The LED light will blink green.
Activate the BT search state. Click on Prozis Ankor in the displayed list. After a successful
connection, the green LED light will be steady.
NOTE: Make sure Ankor is not connected to any other device before pairing it to a new one.
MOBILE PHONE FIXING: see figure C
Tilt the phone above the bracket, and push it upwards. Place the phone into the bracket firmly
against the stand to secure it.
PHOTO SHOOTING/ VIDEO RECORDING : see figure D
EN EN
D
G
7