Hoover CI 5C4D0FB Instructions page 105

The message "SETTINGS" will appear

on the display and the indicator lights of
the "SMART DOOR/EXPRESS" and
"TABS" buttons will be on.
Pressing the "PROGRAMME SELECTION"

button until the "MEMO FUNCTION"
parameter is selected.
Parameter adjustment is performed by

pressing the "SMART DOOR/EXPRESS"
and "TABS" buttons to change the value
from "MEMO MODE ON" to "MEMO
MODE OFF" and vice versa.
Switch off the dishwasher by pressing the

"ON/OFF" button for 3 secs to confirm
the new setting.
To turn the alarm on again, follow the same
procedure.
Enabling or disabling DEMO MODE
(be used exclusively in stores)
Enabling
The dishwasher must ALWAYS be off
before you start this procedure.
1. Open the door.
2. Turn on the appliance using the
ON/OFF button.
3. Press the "PROGRAMME SELECTION"
and "DELAY START" buttons together
for 5 seconds.
4. "DEMO MODE ON" will appear on the
display.
5. If no button is pressed for 30 seconds,
the programme will start, simulating the
start of a wash programme.
The PROGRAMME SELECTION/ OPTIONS/
DELAY START options are enabled,
and by pressing these buttons you can
simulate the product's
without starting a wash.
Disabling "Demo mode"
Once installed, if the appliance works
correctly but the wash cycle does not
start upon pressing the Start button,
"Demo mode" may not have been
disabled.
The dishwasher must ALWAYS be off
before you start this procedure.
1. Open the door.
2. Turn on the appliance using the
3. Press the "PROGRAMME SELECTION"
4. "DEMO MODE OFF" will appear on the
5. Switch off the appliance.
functioning
105
WARNING
ON/OFF button.
and "DELAY START" buttons together
for 5 seconds.
display.