Atag DW8114XT Notice D'utilisation page 80

Table continued from last page
Problem
The dishwasher does not start.
Possible causes
The Start/Stop start button has
been pressed for too short a
time.
The door is not properly closed.
You have opened the
dishwasher to add more dishes
while a program is in progress.
The door lock has not clicked
into place and locked.
A fuse/circuit breaker has been
tripped.
The plug is not plugged into the
wall socket.
The water tap is turned off.
Overflow/leaks.
A whirring sound (the drainage
pump) is heard from the
dishwasher and does not stop
when the main power switch is
turned off.
Check that the Delayed Start
option has not been selected.
Troubleshooting
Action
Press and hold Start/Stop until
the display shows "Program
started, close door".
Check.
Close the door and wait. After a
while, the dishwasher continues
the program.
Check the door lock. If it has not
clicked into place and locked,
open the door.
Press and hold the left
navigation button and the Auto
Open option button until the
display starts flashing. Wait until
it stops flashing (60 seconds).
Close the door. Check that the
door lock clicks into place and
locks.
Check.
Check.
Check.
Check.
Turn off the water tap. Pull out
the plug and call the service
department.
Press and hold Start/Stop for
three seconds if you want to
cancel the Delayed Start option.
33