Hoover H-FRIDGE 300 NO FROST HOBT3518FWK Mode D'emploi page 11

Wi-Fi Use
To activate the Wi-Fi, long press the Wi-Fi key for 2 seconds, the Wi-Fi icon will turn on and
an acoustic signal is made.
If the Wi-Fi has not been configured yet, when the refrigerator turns on, it will
automatically enter the configuration mode and keep this status for 30 minutes. To use
the configuration mode:
•
Press the Wi-Fi key for 2s, the refrigerator enters the Wi-Fi configuration mode
and an acoustic signal is made. The Wi-Fi icon starts blinking.
•
Follow in app instructions to configure the Wi-Fi (see above).
•
Once the Wi-Fi is configured and the connection established, the Wi-Fi icon is on
and fi3ed.
•
After 30 minutes without performing any operation, the Wi-Fi will automatically
exit the configuration mode.
•
If the Wi-Fi has already been configured, it will automatically reconnect
according to the configuration information.
To reset the Wi-Fi, long press the Wi-Fi key and Mode for 2s, the Wi-Fi is reset and an
acoustic signal is made. After this, the Wi-Fi will automatically enter the configuration state
(Wi-Fi icon will start blinking again).
To turn off the Wi-Fi, press the Wi-Fi key for 3s.
Radio-module - Technical data
Frequency rate (OFR)
Channel frequencies
Maximum power(EIRP)
Radio equipment type is in compliance with Directive 2014/53/EU.
2400 MHz-2843.5 MHz
2412...2472 MHz(step size 5 MHz)
100 mW
EN 8