Safety Switch; Important Safeguards - Valentine TF3 Manuel D'utilisation

Safety switch:

Once the heating element
is raised more than 5
mm, the safety switch is activat-
ed and interrupts the current.
Make sure that the heating ele-
ment housing is resting properly
on the edge of the tank and that
the pin attached to the chassis
goes into the housing.

Important safeguards:

Before connecting the power and/or filling with oil, set the switch [1] to
"0". Never heat up without oil!
Pour oil into the tank up to the «MAX» level mark [4].
It is not advisable to use animal and vegetable fats that solidify. If the use of such fat cannot
be avoided, it must be melted in a pan. Never melt hard blocks of fat on the heating element.
Always top up with oil after use. When the oil level is too low the efficiency drops considerably
and the oil is overheating.
14
Commissioning

Remove all remaining protective
plastic sheets.

Clean the tank and heater [8]
with warm, soapy water then dry
well.
 see section "maintenance"