Peavey BASIC Serie Mode D'emploi page 5

BASIC 112 REAR PANEL
1. REMOVABLE AC POWER CORD
This receptacle is for the IEC line cord (included), which provides AC power to the unit. Connect the
line cord to this connector and to a properly grounded AC supply. Damage to the equipment may occur
if an improper line voltage is used. (See voltage marking on unit.) Never remove or cut the ground pin
of the line cord plug. This unit is supplied with a properly rated line cord. When lost or damaged,
replace this cord with one of the proper ratings.
2. POWER SWITCH
Placing this switch in the "ON" position applies power to the unit when proper power is supplied to the
AC Power Cord.
4. POWER LED
This LED illuminates to indicate power has been applied to the unit and the unit is on.
5. INPUT
This 1/4" mono jack is the input for your bass guitar. Always use a high quality, shielded instrument
cable when connecting your bass guitar to the input jack.
6. INPUT SELECT SWITCH (Active/Passive)
This switch, when placed in the "IN" position, adds a 10 dB pad to the input stage of your Basic 112.
When using active pickups place this switch in the "IN" or active position to avoid overdriving the
input stage. When using standard or passive pickups, leave this switch in the "OUT" or passive
position.
7. PRE GAIN
The Pre Gain control sets the input level to the amplifier. Adjusting this control fully clockwise will
result in maximum gain. This setting may change from instrument to instrument due to the various
electrical characteristics found in bass guitars.