Publicité
Les langues disponibles
Les langues disponibles
MINX® 110
SPECIFICATIONS
SYSTEM SPECIFICATIONS:
Mains Fuse = 1 amp
Mains Voltage =120 VAC 60 Hz
Power Consumption = 50 watts
Hum and noise: Typically greater than -80 dB
Internal Speaker: 10 inch 8-ohm bass
instrument speaker
POWER AMPLIFIER SECTION:
PROTECTION:
Current limit protection
Thermal protection
DDT speaker protection circuit
GENERAL INFORMATION:
Minimum load = 4 ohms
DDT dynamic range: +12 dB
Input sensitivity: 1 VRMS
One 1/4-inch external speaker jack in parallel
with internal 8-ohm speaker
POWER OUTPUT:
50 watts (14.14 VRMS) into 4 ohms with no
more than 5% THD+N
35 watts (16.73 VRMS) into 8 ohms with no
more than 5% THD+N
PREAMPLIFIER SECTION:
SETTINGS FOR FOLLOWING MEASURE¬
MENTS UNLESS OTHERWISE NOTED:
Volume = 5(12 o'clock)
Bass = 0 (12 o'clock)
Mid = 0 (12 o'clock)
High = 0 (12 o'clock)
High Boost = out
INPUT SENSITIVITY (Level to achieve full power):
Nominal input: 75 mV RMS
Minimum input: 10 mV RMS (pre gain and
master fully CW)
Maximum input: 3.2 V RMS (maximum
signal at input before clipping occurs)
EQUALIZATION:
Passive Bass
Passive Midrange
Passive High
High Boost: + 8 dB @ 8 kHz
EFFECTS LOOP:
Set for 0 dB (1VRMS) with Volume @ 5 and
nominal input signal
NOISE:
Typically greater than 90 dB below full power
@ 8 ohms
Publicité
