KitchenBrothers KB4027 Manuel D'utilisation page 33

Change direction of door rotation (if necessary)
ATTENTION!
◊ Never lay the product flat, this may damage the cooling system.
• Required tools: cross screwdriver, flat screwdriver, hex wrench.
• Required people: 2.
1. Make sure the product is unplugged and empty.
2. Tilt the product backwards so you have access to the feet. Rest the product on
something solid so it does not slip while flipping the door.
3. Remove the upper right hinge cover.
4. Loosen the screws and take off the hinge bracket (A).
5. Remove the upper left screw cover (B).
6. Move the cover from left to right (C).
7. Unscrew the bottom hinge and remove the legs on both sides (D).
8. Unscrew and remove the pin. Turn the bracket over and replace the pin on the
bracket (E).
9. Install the bracket on the other side of the product and replace both legs (F).
10. Carefully remove the door seal, rotate it 180 degrees and press it back onto the
product. The magnetic surface of the door seal should match the direction of
the door (G).
11. Turn the door, replace it and screw the upper hinge on the left side. Make sure
the door is aligned horizontally and vertically so that the seals are closed on all
sides before permanently tightening the upper hinge (H).
12. Replace the screw cover and hinge cover (I).
A
D
B
E
English
C
33