Publicité
Les langues disponibles
Les langues disponibles
4. Assembling
Tighten all individual parts and pre-assembled parts!
•
Check the firmness again before each training session!
•
Have a second person ready to help you.
•
4.1 RAISING AND FIXING THE CONSOLE STANDS
2 x
2 x
4 x
Hex 6 mm
B
D
A
The console stands (2L and 2R) are pre-assembled to the base frame (1).
•
Have a second person assist you with this step.
One person lifts the left console stand (2L) on the base frame (1) as shown in the figure.
•
CAUTION! Make sure not to pinch fingers!
•
Then, fasten the left console stand (2L) to the base frame (1) with one long hex bolts (A) and two
washers (D). Use the provided hex wrench (Allen wrench; HEX).
Additionally, fasten the console stand (2L) with one short hex bolt (B) and a washer (D). Insert it from
•
above, as shown in the figure, and fasten it with the hex wrench.
Repeat the above steps for the right console stand (2R).
•
4.2 FIXING THE LOWER COVERS
Put the covers ('H' and 'I') on the lower end of the console stands.
•
Fasten the covers with one cross-head screw each ('C'). Use the HEX key.
•
G
C
28
2L
A
B
D
1
2R
C
H
B
D
A
2 x
C
Hex 5 mm
G
H
Publicité
