Philips Wet&Dry S9041/12 Mode D'emploi page 41

Problem
The shaver is not
entirely clean
after I clean it in
the SmartClean
system.
Possible cause
You have not
placed the shaver in
the SmartClean
system properly, so
there is no electrical
connection
between the
SmartClean system
and the shaver.
The battery of the
shaver is not
charged sufficiently.
The cleaning
cartridge needs to
be replaced.
You have used
another cleaning
fluid than the
original Philips
cleaning cartridge.
The drain of the
cleaning cartridge is
blocked.
English
Solution
Press down the top cap
('click') to ensure a proper
connection between the
shaver and the SmartClean
system.
If the battery of the shaver
is not charged sufficiently,
the SmartClean system
may not work properly. The
shaver needs to be able to
switch on briefly during the
rinsing phase. Charge the
shaver for a short time
before you use the
SmartClean system to
clean your shaver.
Replace the cleaning
cartridge (see 'Replacing
the cartridge of the
SmartClean system').
Only use the original
Philips cleaning cartridge.
Remove the cartridge from
the SmartClean system and
push the hairs down the
drain with a toothpick.
41