Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
UNPACKING & SETUP SUMMARY
1. Pull lid latches in an outward motion, remove
blower and some accessories that may
have been shipped in the tank.
2. Assemble the casters, following the instructions
under CASTER ASSEMBLY in this manual.
3. Attach accessories following the instructions
in this manual.
4. Before replacing the blower, refer to this
manual to ensure you have the proper lter
installed for the cleaning operation.
5. Replace the blower, and apply pressure
with thumb to each latch until it snaps
tightly in place. Make sure all lid latches are
clamped securely.
6. Insert the hose end into inlet of tank.
7. Attach the extension wands to the end of the
hose. Apply slight pressure until tting is tight.
8. Attach one of the cleaning accessories
(depending on the cleaning requirements) to
the extension wands. Twist slightly to tighten
the connection.
9. Plug the cord into the wall outlet. The vacuum
is ready for use.
10.To reduce the risk of injury from accidental
starting, always shut off vacuum and
disconnect the power plug from the wall
outlet before installing any part or
cleaning accessory.
WARNING:
Do not alter the plug in any way. If the plug
does not t fully in the outlet, reverse the plug.
If it still does not t, contact a quali ed
electrician to install the proper outlet.
WARNING:
To reduce the risk of re or explosion, do not
operate this vac in areas with ammable gases,
vapors or explosive dust in the air. Flammable
gases or vapors include but are not limited to:
lighter uid, solvent-type cleaners, oil-based
paints, gasoline, alcohol or aerosol sprays.
Explosive dusts include but are not
limited to: coal, magnesium, aluminum, and
grain or gun powder. Do not vacuum
explosive dust, ammable or combustible
liquids or hot ashes. Do not use this vac as
a sprayer for any ammable or combustible
liquid. To reduce the risk of health hazards
from vapors or dusts, do not vacuum
toxic materials.
WARNING:
The operation of any utility vac can result in
foreign objects being blown into the eyes,
which can result in severe eye injury. Always
wear safety goggles complying with ANSI
Z87.1 (or in Canada, CSA Z94.3) before
starting operation.
CASTER ASSEMBLY
1. Invert dust tank, take the caster to align the
tank bottom sinking place. Secure with
screws provided.
2. Return dust tank assembly upright.
ACCESSORY BAG HOLDER BRACKET
ASSEMBLY
Attach 2 accessory bag holder brackets to tank
with 4 self-tapping screws provided.
(See Illustration F1）
ACCESSORY BAG HOLDER ASSEMBLY
Place the accessory bag holder into the hole
of bracket.(See Illustration F2)
F1
CORD STORAGE & RELEASE
The cord can be wrapped on the handle
as shown in F3. Meanwhile, it can be released
in a second by press the Cord release hook
as shown in F4.
F3
4
F2
3
F4
Publicité
