DeWalt DXV212P Guide D'utilisation page 10

ENGLISH
NOTICE:
After cleaning, check the lter for tears or small
holes. Do not use a lter with holes or tears
in it. Even a small hole can cause a lot of
dust to come out of the vac.
Replace it immediately.
NOTICE:
Before installing the lter on the vac, clean the
area of the lid so that the lter will seal against
the lid and stop small particles from bypassing
the lter bag. If the lter is clean and not
damaged, replace it on the lter cage.
If it cannot be reused, place a new lter over
the lter cage.
NOTICE:
Clean the lter in an open area. Cleaning should
be done outdoors and not in living quarters.
CLEANING
To keep the wet/dry vac looking its best, clean
the outside with a cloth dampened with warm
water and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and
mild soap.
3. Wipe with dry cloth.
STORAGE
Before storing the vac, the dust tank should be
emptied and cleaned. The cord should be
wrapped and hung on the handle and the hose
may be wrapped around the lid with the
hose holder. Accessories should be kept in
accessory bag so they can be readily available.
The vac should be stored indoors.
TROUBLESHOOTING
Minor problems often can be xed without calling
customer service.
PROBLEM
Check power cord, plugs and outlet.
Motor does not run
Ensure the on/off switch is in the
ON position ("I" or "II").
Remove blockages in the nozzle,
extension wands, hose or lter.
Replace the disposable dust bag.
Suction capacity
Check for proper installation of the
decreases
lter.
Clean or replace the lter.
Empty the dust tank, refer to
the tank
instructions.
Thermal overload has been tripped:
1. Turn the vacuum off and
Vacuum stops
2. Empty the tank, if needed.
running
3. Allow the unit to cool.
4. Plug the power cord into an
Check for proper installation of the
Dust comes out
Ensure lters are not damaged;
while vacuuming
replace if necessary.
Ensure lter seals are in place and
are secure.
8
SOLUTION
Operating
under
disconnect vacuum cleaner from
power source.
appropriate outlet and turn on/off
switch to the ON position ("I" or
"II") to test. If vacuum will not
restart call 1-888-899-0146.
lter.
Empty