ANSMANN 1700-0109 Manuel page 8

WIRELESS
Wireless charge output is activated by pressing the power button. Then
place your Qi-capable device on the marked area of the Powerbank. The
charge LEDs illuminate white as soon as the device is charged.
When charging the Powerbank via micro USB / type C, simultaneous
charging of your end-device is not possible.
Simultaneous charging of multiple end-devices is possible with restric-
tions. This depends on the total charge current required.
Please disconnect your device from the POWERBANK once the charging
process is complete. The POWERBANK switches off automatically if it is
not charging a device.
The Powerbank may heat up a little depending on the charge/discharge
current.
> ADDITIONAL FUNCTIONS
On the rear of the Powerbank a small LED strip has been incorporated,
which can be used as a small torch. The LED strip is activated by quickly
pressing the power button twice. Switch off in the same way - by quick-
ly pressing the power button twice.
TECHNICAL DATA
1. Cell type:
2. Capacity:
3. Input:
4. Output:
5. Accessory:
6. Operating temperature: 10°C to 40°C
7. Charge time:
8. Protective functions:
9. Display:
Deutsch |
Italiano | Nederlands | Dansk | Suomalainen | Norsk | Svenska
Li-Po rechargeable battery pack
8000mAh | 29.6Wh
Micro-USB: 5V | 2.0 A
USB Type C: 5V | 2.0 A
2x USB: 5V | max. 2.1 A
Wireless: 5V | max. 1.0 A
Charge cable (USB to Micro-USB)
Micro-USB / Type C: ca. 4h
Over-charging protection, deep discharge
protection, overload protection, short-cir-
cuit protection
LED display
English
| Français | Español | Português