Publicité
Les langues disponibles
Les langues disponibles
TIMER BUTTON: To set the timer from 0H-24H, which is the number of hours it will run. 0H will
5.
display and then adjust to the number of hours you would like to set, using the up and down
buttons (2 and 3).
Noted: The heaters and their remote controls have the same frequency, so it is possible to
control several heaters with just one remote.
Inserting Batteries (not included)
Insert 2 AAA/ Alkaline type batteries into your remote control
1. Flip the backside of your remote control and pull-out battery cover. Insert the batteries in
accordance with the instructions and polarity the batteries.
2. Change the batteries in the same way depicted above.
NOTICE:
1. Replace the old batteries with the same type batteries. Otherwise, your heater may not
function well.
2. Pull out the batteries in case of long terms of disuse to prevent leakage which may impair your
remote control.
3. Do not allow water or liquid to get into the remote control.
Caution:
When the appliance is not operated for a long period of time, cleaning or maintenance is
conducted or when the location of the heater is changed, the heater should be turned to OFF and
unplugged from the electrical connection.
Periodic inspection and removal of dirt and contaminants will ensure that equipment can be
operated safely.
Troubleshooting
1. Check if the power cord is plugged into an electrical outlet, if not, plug in.
2. Check if electricity to the main fuse is working
3. Error code shows on display
E1 Error on display: Control unit overheat. Cooling down the heater after 1 hours and restart
heater.
E2 Error on Display: Tip over function, make heater less than 60°working angel and restart heater
L1,2,3,4 shows in display, but no heat: Bulb is damaged. Arrange for replacement bulb with local
Dealer.
MAINTENANCE
Attention! Careful and regular maintenance of your heater considering our instructions assume
great importance so as to attain a long efficient operation of your appliance.
1. Check the filthiness of the Reflector and IR-Filament at least once a month. If necessary, apply
cleaning and maintenance instructions.
Publicité
