To Use; Care And Maintenance; Disposal; Technical Data - Beurer KS 34 Mode D'emploi

5. To Use

1. Press the Power Button to activate the scale and wait until the LCD Display reads zero.
2. Press the UNIT button on the bottom of the scale to set the units of measurement: grams (g), kilograms
(kg), pounds and ounces ( lb/oz), or ounces (oz).
3. Press the TARE button to reset the scale to zero.
4. Place the item to be weighed onto the middle of the scale.
5. The item's weight will appear on the LCD Display; if no buttons are pressed, the LCD Display will shut
off after about two minutes.
6. To weigh additional items without removing the original item, press the "TARE" Button to "zero out"
the display.
7. To retain the measurement on the LCD Display, press the HOLD button after the measurement stabilizes.
8. To shut the scale off, press and hold the Power Button for about three seconds.
9. If "OL" appears in the LCD Display, too much weight has been placed on the scale; only weigh items
up to 33 pounds/ 15 kg.

6. Care and Maintenance

• Clean the scale with a damp cloth and a mild detergent. Do not immerse the scale in water or rinse it
under running water.
• Store the scale in a cool, dry place when not in use; ensure no objects are placed on the scale during
storage.

7. Disposal

Observe the local regulations for material disposal. Dispose of the device in accordance with local regulations.
If you have any questions, please contact the local authorities responsible for waste disposal.

8. Technical Data

Measuring range: 0.2 oz – 33 lb/5 g – 15 kg
Increments: 0.1 oz (1 g)
Dimensions: 7.9 in x 10.4 in x 0.8 in / 200 mm x 263 mm x 20 mm (W x H x D)
Power: 4 x 1.5V AAA batteries

9. FCC Compliance Information

Kitchen Scale KS 34
Responsible Party – U.S. Contact Information:
Beurer North America LP
1 Oakwood Boulevard, Suite 255
Hollywood, FL 33020
United States
1-800-536-0366
info@beurer.com
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference; and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harm-
ful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
4