Publicité
Les langues disponibles
Les langues disponibles
Searching for the Time and Date
1
1
Turn on the power of the equipment to be used.
2
Press SEARCH/AUDIO ON in stop mode until the
time/date search indicator flashes in the display
window and on the monitor screen.
When CONVENTION is selected for T/D
SEARCH on the GENERAL SET menu:
In the display window
When NEW is selected for T/D SEARCH on the
GENERAL SET menu:
In the display window
3
2
4
1 H 1 2 M 0 6 S
T / D S E A R C H
0 1
1 2
Hour
Date
On the monitor
1 H 1 2 M 0 6 S
T / D S E A R C H
0 1
1 2 2 0
Minute
Hour
Date
On the monitor
3
Press MENU + or – to set the date and press
MENU B to move the flashing to the time. Press +
or – to set the time. Set the minute (when NEW is
selected) on the same way.
4
Press FF M or REW m.
The cassette stops at the portion when you set the
time and date and the still picture playback is
displayed.
The time/date search mode is automatically
cleared.
Notes
• When T/D SEARCH is set to NEW on the GENERAL
SET menu, the time/date search mode works during
recording in from 2H to 96H (when using T-120 tape)
mode, from 2H to 128H (when using T-160 tape) mode in
the SP mode, or from 6H to 168H (when using T-120 tape)
mode, from 8H to 224H (when using T-160 tape) mode in
the EP mode.
• If the tape reaches its end during searching, the tape is
rewound and the unit enters the stop mode at the beginning
of the tape.
• Be sure to set T/D SEARCH on the GENERAL SET menu
to the same setting as the tape was recorded with.
Otherwise, searching for the time and date cannot be done
properly.
• You can use the T/D SEARCH only when the alarm speed
is set to SP 2H (when using T-120 or T-160 tape in SP
recording mode), EP 6H (when using T-120 tape in EP
recording mode), or EP 8H (when using T-160 tape in EP
recording mode) and the recorded section is longer than 20
seconds.
47
Publicité
