Publicité
Les langues disponibles
Les langues disponibles
WARNING!
Hard water leaves a white coating on dishes and inside the dishwasher. It is therefore important
that you select the right setting for the water softener! See Water hardness.
Never run the dishwasher with an empty salt compartment if the water supply has a water hardness
in excess of 5°dH (9°fH / 6°eH / 0.9 mmol/l).
Basic settings
Open the door. Press
"This is a first time setup." is shown on the display. It is important that you choose the right settings
to ensure good dishwashing results.
Select setting with
or . Confirm selected setting with
Settings
1.
Language
2.
Rinse aid 0/1/2/3/4/5
Pre-selected at factory: 4
3.
Water hardness
0/1/2/3/4/5/6/7/8/9
Pre-selected at factory: 4
4.
TAB On/Off
(All-in-one detergent)
Pre-selected at factory: Off
To change the selected setting, see the chapter Settings.
Before washing for the first time
.
Select the language to be shown on the display.
Drying is faster and a better result is achieved if you use
rinse aid. You will also achieve a better dishwashing result
with clear and spotless dishes.
The rinse aid dispenser can be adjusted between 0 (Off)
and 5 (High dosage).
Adjusting the water softener. Select a setting depending on
the hardness of the water supply. It is important that this
setting is correct!
For a water supply with a hardness above 5 °dH (9 °fH /
6 °eH / 0.9 mmol/l), fill with salt.
For a water supply with a hardness below 6°dH (10°fH /
7°eH / 1.0 mmol/l), select 0. The water softener is
deactivated and no salt needs to be added.
Activate this setting when using an all-in-one detergent that
contains rinse aid.
This setting reduces the rinse aid dosage and affects how
often the dishwasher's built-in softener is regenerated.
.
7
Publicité
