Lotus CPT-66ET Instructions Pour L'installation Et L'emploi page 21

Attention! The manufacturer will neither be held responsible for, nor will give any compensation during the guarantee
period for any damage caused, and which is due to inadequate installations not compliant with the instructions.
Before using the appliance, it is necessary to clean it carefully, especially the tub (see paragraph "cleaning and care").
Check the connection of the appliance and start it up following the instructions.
Attention! Use the appliance only under surveillance.
- Never start up the appliance without water.
With pasta cookers it is possible to cook pasta, vegetables, rice, eggs, legumes, etc.
The system must be connected to a drinking water supply with the following characteristics. Failure to do so
automatically invalidates the guarantee
Total hardness: 0,5 to 5°F to prevent the build-up of lime-scale
Pressure: 50 to 250 kPa (0,5-2,5 bar).
Chlorine ion concentration (Cl-): not more than 10 ppm (acceptable value) to avoid damaging the internal steel
elements
pH: over 7
Electrical conductivity: 50 to 2000 S/cm (20°C)
Check that the water drainage tap is turned off.
Fill the tub with water, keeping the button of the filling knob pushed down until the level indicated by the symbol
stamped inside the tub is reached. Switch on the switch situated above the appliance.
Switch on the main switch installed above the appliance. Turn the control knob corresponding to the hotplate from
position "0" to the degree of coking desired, between 1 and 4.
The white light shows that the heating element is working
(lever in vertical position) which can only be reached through the cabinet door situated below the appliance.
Attention! During cleaning, do not wash the external parts of the appliance with direct sprays of water or with
high pressure.
After every use, clean the appliance thoroughly. Daily cleaning after switching off the appliance ensures the perfect
functioning and long life of the appliance.
Before starting to clean the appliance, disconnect the power supply. The parts in steel must be washed with hot water
and neutral detergent, then rinsed thoroughly in order to eliminate all traces of detergent; after which, dried with a dry
cloth. Do not use abrasive or corrosive detergents.
GB
IT
STARTING UP
INSTRUCTIONS FOR USE
WATER SUPPLY CHARACTERISTICS
TURNING ON
To turn off the appliance, turn the knob into position "O".
The user should be equipped with a suitable container for the
drained water. Insert the outlet pipe as shown on the
drawing and place the container in position. Push the safety device
(A) upwards and move lever (B) to the symbol.
Important: pay attention to the clearance between the appliance
and the edges of the stands.
To carry out this operation, it is necessary to open the outlet tap
CLEANING AND MAINTENANCE
21
IE
CH
EMPTYING THE TUB MOD. CPT...
EMPTYING THE TUB MOD. CP...
--