Publicité
Les langues disponibles
Les langues disponibles
16
4)
Remove the two nuts (a) that hold the manifold support bracket to the cooking box.
Allow the manifold support bracket to pivot down away from the cookbox, releasing
the valve assembly from the burners (b).
5)
Slide the burner assembly out from under the guide screw and washer (a) in the
corners of the cooking box.
6)
Lift and twist the burner assembly slightly, to separate the crossover tube (b) from
the burners. Remove the burners from the cooking box.
7)
To reinstall the burners, reverse 3) through 7).
CAUTION: The burner openings (c) must be positioned
properly over the valve orifices (d).
Check proper assembly before fastening manifold in place.
WARNING: After reinstalling the gas lines, they should be
leak checked with a soap and water solution before using
the barbecue. (See Step: "Check for gas leaks.")
®
CROSSOVER
IGNITION SYSTEM OPERATIONS
®
If The Crossover
Ignition System fails to ignite the BURNER 1, light BURNER 1 with a
match. If BURNER 1 lights with a match, then check the Electronic Ignition System.
•
Check that both of the ignition wires are attached at the igniter module properly.
•
Check that the Electronic Ignition Button is working by listening and looking for
sparks at BURNER 1.
REPLACE BATTERY IF NECESSARY
AAA alkaline battery only. See illustration:
If the Electronic Ignition System still fails to light, contact the Customer Service
Representative in your area using the contact information on our web site. Log
onto www.weber.com
®
.
All manuals and user guides at all-guides.com
MAINTENANCE
a
b
d
c
WWW.WEBER.COM
®
Publicité
