BOMANN 666029 Mode D'emploi page 44

• Only use the 16 g CO
use of other cartridges will invalidate the warranty.
• Do not remove the CO
• Only dispense of the CO
Unpacking the Appliance
1. Remove the appliance from its packaging.
2. Remove all packaging material such as plastic films, filler
material, cable ties and cardboard packaging.
3. Sensitive surfaces are possibly protected with foil.
Remove these foils.
4. Check the content for any missing parts.
5. In the event that the packaging content should be incom-
plete or if damages are noticeable, do not operate the
appliance. Return it to the dealer immediately.
NOTE:
There may be dust and production residue on the
appliance. We recommend cleaning the appliance as
described under "Cleaning".
Overview of the Components /
Scope of Delivery
1 Buttons / (temperature adjustment)
2 LED temperature indicator
3 Pressure regulator for carbon dioxide
4 Beer hose cover
5 Fitting for the connections
6 CO cartridge holder
2
7 Lid
8 CO feed valve
2
9 Keg holder
10 Beer connection valve
11 Ventilation slots
12 Power cord
13 Main switch
14 Collecting tray
15 Drip tray
16 Drain lever
17 Beer tap
18 Lid opener
19 Tap handle
20 Cleaning balloon
21 Cleaning hose
22 Universal adapter
23 CO cartridge
2
24 Adapter for Heineken kegs
No Illustration
Keg tap
Spare silicone ring for the keg tap thread
Spare CO cartridge
2
44
BZ6029CB_IM
cartridges intended for the dispenser. The
2
cartridge before it is completely emptied.
2
cartridge when empty.
2
Spare universal adapter
Spare adapter for Heineken kegs
• When transporting the beer dispenser, always carry it
holding the bottom edge and not by the beer tap, lid or
power cord.
• Only use the dispenser with the correct beer keg.
• Do not place any objects on the dispenser.
• Follow the instructions on the kegs.
• Check that the kegs are tight and undamaged! Ensure
that the keg lid is not dented so that the clamps of the
dispensing unit can grip under the edge of the lid.
• Do not use beer that has already reached the best
before date.
• Before placing the keg into the appliance, store it in a
cool environment (but not in the freezer compartment)
for 12 hours.
• Never shake the keg before using it.
• Do not expose the kegs to direct sunlight.
WARNING:
Before fitting or removing any parts, always disconnect
the plug from the mains socket!
1. Place the beer dispenser on a stable, horizontal, level
and non-slip surface. Ensure that there is at least 15 cm
of space around the dispenser for optimal operation.
2. Place the drip tray on the collecting tray. Now, slide the
collecting tray to the front of the appliance until it clicks
into place. Make sure the collecting tray does not pro-
trude beyond the base.
3. Attach the tap handle. The flattened
side of the handle points forward. En-
sure that the silicone ring is in the right
place. Make sure the handle is fully
seated on the tap.
4. Dispensing unit: Make sure the silicone
ring has been inserted into the threaded
part of the keg tap. Then put the fitting
through the barrel holder. Make sure the
lug on the fitting is seated in the recess
of the keg holder. Screw the keg tap
onto the fitting. Now the keg holder is
sitting between the fitting and the keg tap.
Notes for Use
Installation
07.03.19