Swing Operation; Timer Operation - Electrolux EXO27HEIWE Manuel D'utilisation

20 www.electrolux.com

Swing Operation

A

Timer Operation

SET TEMPERATURE( C)
AUTO FAN
COOL HIGH
DRY MED
HEAT LOW
TEMP
ON/OFF
MODE
FAN SPEED
SWING TIMER ON
ECONOMY
TIMER OFF
ION
RESET LOCK
FOLLOW
LED
TURBO
ME
DISPLAY
SET TEMPERATURE( C)
AUTO FAN
COOL HIGH
DRY MED
TIMER ON
LOW
HEAT
TEMP
ON/OFF
MODE
FAN SPEED
SWING TIMER ON
ECONOMY
ION TIMER OFF
RESET LOCK
FOLLOW
LED
TURBO
ME
DISPLAY
1. When press the button (A) once and
quickly, the air flow direction setting
feature of the louver is activated. The
moving angle of the louver is 6º for
each press. Keep pressing the button
to move the louver to the desired
position.
2. If keep pressing the SWING button
without releasing for 2 more seconds,
the auto swing feature of the louver is
activated. The horizontal louver would
swing up/down automatically. Press it
again to stop.
When the louver swing or move
to a position which would affect
the cooling and heating effect
of the air conditioner, it would
automatically change the swing/
moving direction.
Press the TIMER ON button (A) can set
the auto-on time of the unit. And press the
TIMER OFF button (B) can set the auto-off
time of the unit.
To set the Auto-on time.
1. Press the TIMER ON button. The
remote controller shows TIMER ON,
the last Auto-on setting time and
the signal "h" will be shown on the
LCD display area. Now it is ready to
A
reset the Auto-on time to START the
operation.
B
2. Push the TIMER ON button again to set
desired Auto-on time. Each time you
press the button, the time increases in
30 minutes increments, up to 10 hours,
then at 1 hour increments up to
24 hours.
3. After setting the TIMER ON, there will
be a one-half second delay before
the remote controller transmits the
signal to the air conditioner. Then, after
approximately another 2 seconds, the
signal "h" will disappear and the set
temperature will re-appear on the LCD
display window.