Westinghouse QL0252 Manuel De L'utilisateur page 8

Installation (continued)
INSTALLING THE FAUCET
1 . Carefully take out all the parts of the faucet assembly (C) . The faucet is
pre-assembled, except for the sprayer head .
2 . Take the washer, gasket and retaining ring off of the faucet body .
3 . Place the faucet body carefully through the hole in the sink (B) . A
second person may be required to hold the body in place until the
faucet installation is complete .
4 . From underneath, slide the washer, gasket and retaining ring over
the end of the copper pipe and up to the exposed threaded section of
the faucet . Tighten the retaining ring by hand until it is snug . Using a
wrench or pliers, tighten the assembly .
5 . Gently tighten the two screws on the retaining ring . Do not over tighten .
6 . Screw the sprayer head onto the gooseneck .
7 . Connect the water supply lines (not supplied) to the faucet .
INSTALLING THE STRAINER
1 . Apply a ring of plumber's putty to the underside of the strainer
flange.
2 . Insert the strainer body into the sink .
3 . Assemble the rubber gasket, friction washer and locknut
onto the strainer body from underneath the utility sink . Hand
tighten the locknut .
4 . Connect the plastic flange and tail pipe (not supplied), then
thread the connecting nut through the tail pipe and plastic
flange up to the lower threaded part of the strainer body.
Tighten the connecting nut by hand .
QL0252
Faucet body
Gasket
Retaining ring
Screws
Plumber's putty
or sealant
8
Gooseneck
Sprayer
head
Faucet handle
Washer
Threaded section
Strainer
body
Strainer
basket
Strainer
body
Rubber
gasket
Friction
washer
Locknut