Analog way QUATTRO Manuel Utilisateur page 24

Chapter 4 : FRONT PANEL DISPLAY MENUS DESCRIPTION (continued)
5 [AUDIO] + ENTER.
5-1 [Master volume] + ENTER.
Adjust the audio output level with
5-2 [Audio mode] + ENTER.
Select the output audio mode with
• [Mono]: Set the output in mono mode.
• [Stereo]: Set the output in stereo mode.
5-3 [Audio source] + ENTER.
Select an item with
• [Auto follow]: The audio follows the video image.
• [Input --]: The selected audio input is permanently diffused.
5-4 [Audio level] + ENTER.
This function allows to separately adjusting the level of each audio input. Adjust the level with
NOTE: This function acts on the selected (diffused) audio input.
5-5 [Audio balance] + ENTER.
This function allows adjusting for each input the audio balance. Adjust the level with
NOTE: This function acts on the selected (diffused) audio input.
5-6 [Mute off] + ENTER.
Switch ON or OFF the audio output. Validate with ENTER.
6 [CONTROL] + ENTER.
6-1 [Versions] + ENTER.
Version _._= update version.
I1 to I4 = Identification number.
K, A, B, C, O = status of the internal firmware versions.
6-2 [Transition] + ENTER.
Select an item with
6-2-1 [Fade color] + ENTER.
This function allows selecting the color of the fade during the transition. Select a color (red, green and bleu)
with
displayed onto the output. To obtain the black color, set the 3 levels to the minimum. To obtain the white
color, set the 3 levels to maximum. To obtain the grey color, set the 3 levels in the middle.
6-2-2 [Clean cut] + ENTER.
This function allows a clean switching thanks to a fast freeze of the displayed source. Select a function with
• [From computer]: The CLEAN CUT operates only when switching from a computer source. The
• [From video]:
• [From all]:
6-3 [Sync loss] + ENTER.
Allows to display a frame or a source in case of sync-loss of the selected input. Select an items with
ENTER
6-4 [RS232/LAN port] + ENTER.
Select the needed communication port with
• [RS232]:
• [LAN]:
IMPORTANT: To avoid addresses conflict, configure the LAN communication port (with the LAN setup menu)
NOTE: The RS-232 & the LAN communication ports can not be used simultaneously.
PAGE 24
+ ENTER:
+ ENTER
+ ENTER and adjust the level with
+ ENTER.
others switching operates with a fade color.
The CLEAN CUT operates only when switching from a computer source. The others
switching operates with a fade color.
The CLEAN CUT operates when switching from all sources.
Enables the RS-232 communication port. (Default setting).
Enables the LAN communication port.
before activates it.
+ ENTER.
+ ENTER.
+ ENTER.
+ ENTER. During the adjustment the color is
QUATTRO
+ ENTER.
+ ENTER.
+