HIKOKI WR 36DF Mode D'emploi page 10

English
NAMES OF PARTS (Fig. 1 – Fig. 19)
Hammer case
Anvil (A)
Friction ring (C)
LED Light
Trigger switch
Switch panel
Battery
Hook
Handle
Push button
Motor
Anvil (B)
Friction ring (B)
High / Low mode
selector switch
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
WR36DF / WR36DG
: Cordless Impact Wrench
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/EU
on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
Direct current
V Rated voltage
n
No-load speed
0
min -1 Oscillation per minute
Bpm Impact rate
Ordinary bolt
H
High tension bolt
High / Low mode
indicator lamp
Auto stop mode
selector switch
Auto stop mode
indicator lamp
Latch
Charge indicator lamp
Battery level indicator
switch
Battery level indicator
lamp
Display panel
Groove
Screw
3/4" Drive hex. socket
O-ring
Pin
1/2" Drive hex. socket
10
MT Tightening torque (Maximum)
Square drive size
Weight*
kg
(According to EPTA-Procedure 01/2014)
Switching ON
Switching OFF
Disconnect the battery
Clockwise rotation
Counterclockwise rotation
Remaining battery indicator switch
High / Low mode selector switch
High / Low mode indicator lamp
Auto stop mode selector switch
Auto stop mode indicator lamp
Warning
* Depending on attached battery. The heaviest weight is
measured with BSL36B18 (sold separately).
Battery
Lights ;
The battery remaining power is over 75%.
Lights ;
The battery remaining power is 50%–75%.
Lights ;
The battery remaining power is 25%–50%.
Lights ;
The battery remaining power is less than 25%.
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.