Blackstone 6038 Manuel Du Propriétaire page 19

MODEL: 6038
CLEANING THE BURNER ASSEMBLY
To reduce chance of "flash-back" the procedure below should be
followed at least once a month when spiders are most active or
when your appliance has not been used for a period of time.
VIDEO TUTORIAL
How to Clean Your Burner Tube
youtube.com/watch?v=xKQTCrFCzf8
Ensure that the gas is turned OFF at control knobs and gas
STEP 01
supply. Remove the griddle top.
Carefully detach and
STEP 02
remove the burner.
Clean the inside of
STEP 03
the burner:
• Run a narrow bottle brush
through each burner tube
several times. (DO NOT use
wire brushes)
• Run a stiff wire bent into a small
hook through each burner tube
several times.
• Use compressed air to blow
through the burner tube and
out the burner ports. Check that
air blows through each hole.
(Wear eye protection)
Brush entire
STEP 04
outer surface of burner to
remove grime.
Clean any blocked ports
STEP 05
with stiff wire such as an open
paper clip.
Carefully replace
STEP 06
burners and reattach, with
attention to the location of the
ignition needle.
BLACKSTONEPRODUCTS.COM/SUPPORT
Fuel nozzle Fuel nozzle
Burner opening Burner opening
The gas rail fuel nozzle
must be reengaged within the
burner opening.
TRoUBLESHooTING
CUSTOMER SUPPORT
Visit us online at BlackstoneProducts.com/support
for assistance concerning appliance use, replacement parts, or
your warranty.
CUSTOMER SUPPORT HOURS:
Monday – Friday
7:00 am – 5:00 pm (Mountain Time)
| OWNER'S MANUAL
19