Publicité
Les langues disponibles
Les langues disponibles
EN
4.
Clean dirt and debris from all parts. Replace
spool if it is worn or damaged.
5.
Align the spool tabs (5) with the tab openings (4)
in the base of the spool (3).
5
4
6.
Push the spool cover until it clicks into position.
13.4
REPLACE THE SPOOL
If any parts of the spool retainer assembly are
damaged or worn, replace the damaged part and
reassemble them as following showing
1.
Disassemble the trimmer head. Pull and remove
the spool cover (5).
2.
Clean dirt and debris from all parts.
3.
Loosen the screws (1). Remove the spool (2),
slot cover (3), location housing (4) from the spool
assembly.
4.
Replace with a new spool.
5.
Insert the location housing and slot cover onto the
spool cover, and then put the spool onto the slot
cover to the desired position.
6.
Tighten with the screws.
English
1
2
3
NOTE
1
13.5
INSTALL THE CUTTING LINE
Do not put more than 18 feet of cutting line in at a
time.
1.
Remove the remaining cutting line on the spool.
2.
Line up the slots on the spool cover with the slots
(1) on the trimmer head.
3.
Insert the line into the mounting hole, which is
located inside the eyelet (2). Push the cutting line
until it exits the opposite hole.
4.
Pull the cutting line through until there is an equal
quantity of cutting line on each side.
14
2
3
4
5
NOTE
1
2
Publicité
