Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Error messages
F10
Overfilling water 1
F11
Water outlet fault
F12
Water inlet fault 1
F40
Inlet valve leakage
F41
Heater fault 1
F45
Diverter fault
F52
Water level fault
F54
Overfilling water 2
F56
Circulation pump fault
F67
Water inlet fault 2
F68
BLDC drain pump fault
Press any button to clear the error message.
38
Action
Unblocking the drainage pump. See the chapter Care and
cleaning. If the problem persists, contact your nearest service
centre.
See "Water remains in the dishwasher" under "Problem" in the
table below. If the problem persists, contact your nearest service
centre.
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, contact
your nearest service centre.
Turn off the water tap and contact your nearest service centre.
Turn off the water tap. Remove the plug from the wall socket and
contact your nearest service centre.
Contact your nearest service centre.
Clean the coarse and fine filters. Check that the outer filter on the
inlet hose is not blocked. If the problem persists, contact your
nearest service centre.
Turn off the water tap and contact your nearest service centre.
To avoid water leakage outside the dishwasher, do not remove
the plug from the wall socket until the water tap on the supply line
has been turned off!
Contact your nearest service centre.
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, contact
your nearest service centre.
See "Water remains in the dishwasher" under "Problem" in the
table below. If the problem persists, contact your nearest service
centre.
Publicité
