Sunrise Medical JAY J3 BACK Mode D'emploi page 14

ENGLISH
REMOVAL AND REPLACEMENT
Removal
Following installation and adjustment, the back can be easily
removed from the wheelchair if necessary. To remove, push
each release lever forward to unlock (Fig. 27). Once both
levers are in the forward position, simply lift the back straight
up (Fig. 28) using the handle located on the top of the back.
Proper reattachment after removal
To reattach the back to the hardware receivers, simply line
up the pins to the receivers and push into place (Fig. 29). If
properly inserted the pins will "click" to a locked position.
WARNING
If you are uncertain if you have heard the locking
"click", pull up on the back using the handle to
ensure that it has been securely locked.
Locking Pins (Fig. 30)
The J3 Back comes with two locking pins which, when
secured, prevent the back from being released from the
chair. To lock, insert the pins (A) into the mounting receivers
(B). Simply remove the pins if the quick-release capability is
desired.
J3 Back 106109
RE MOV AL A ND RE PLA CE MEN T
14
Figure 27
Figure 28
B
Figure 29
Figure 30
A
EU=Rev.4.0