Suncast GLIDETOP BMS4950 Serie Instructions D'assemblage page 14

Insert the tabs on the front left side panel (F) into the slot in the front
13
floor panel (A). Slide the front left side panel to lock in place.
NOTE: The edge of the front left side panel overlaps the outside of the
rear left side panel (E).
F
E
A
Insert the ends of the support tube (U) across the side panels (B, F).
15
Be sure the support tube rests in the curved recesses as shown.
F
U
F
U
B
Using the easy driver (DD), attach the front left side panel (F) to the rear
14
left side panel (E) with two easy bolts (EE). DO NOT over tighten.
F
Position and center the rear roof panel (I) across the side panels (C, D, E)
16
and over the roof support bar (U). Be sure the rear roof bar support (T)
rests securely on the support tube.
T
U
E
14
x2
EE
E
I
C
DD