Suncast GLIDETOP BMS4950 Serie Instructions D'assemblage page 12

Using a phillips screwdriver, attach the floor panels (A) together with six
5
screws (AA).
Place and center the floor assembly onto the prepared foundation.
AA
A
Insert the tabs on rear right side panel (C) into the slot in floor panel (A).
7
Slide the rear right side panel to lock in place.
NOTE: The edge of the rear right side panel overlaps to the inside of the
front right side panel (B).
x6
A
B
A
Insert the tabs on the front right side panel (B) into the slots in the floor
6
panel (A). Slide the front right side panel to lock in place.
NOTE: The edge of front right side panel with hinge tabs will be the front
of the shed.
hinge tabs
A
front
Using the easy driver (DD), attach the front and rear right side panels
8
(B, C) together with two easy bolts (EE). DO NOT over tighten.
C
DD
12
B
x2
EE
B
C