Télécharger Imprimer la page

Haier HFR7819ENGC Manuel D'utilisation page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 238
GB
WARNING!
► Unplug the appliance in the event of a power interruption or before
cleaning. Allow at least 7 minutes before restarting the appliance, as
frequent starting may damage the compressor.
► WARNING: Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are of the type
recommended by the manufacturer.
Maintenance / cleaning
► Make sure children are supervised if they carry out cleaning and
maintenance.
► Disconnect the appliance from the electrical supply before
undertaking any routine maintenance. Allow at least 5 minutes
before restarting the appliance, as frequent starting may damage
the compressor.
► Hold the plug, not the cable, when unplugging the appliance.
► Do not clean the appliance with hard brushes, wire brushes,
detergent powder, petrol, amyl acetate, acetone and similar organic
solutions, acid or alkaline solutions. Please clean with special
refrigerator/freezer detergent to avoid damage. Eventually use
warm water and baking soda solution - about a tablespoon of baking
soda to a litre/quart of water. Rinse thoroughly with water and wipe
dry. Do not use cleaning powders or other abrasive cleaners. Do not
wash removable parts in a dishwasher.
► Do not scrape off frost and ice with sharp objects. Do not use
sprays, electric heaters like heater, hair dryer, steam cleaners or
other sources of heat in order to avoid damage to the plastic parts.
► WARNING: Do not use mechanical devices or other means to
accelerate the defrosting process, other than those recommended
by the manufacturer.
► If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
► Do not try to repair, disassemble or modify the appliance by
yourself. In case of repair please contact our customer service.
► If the illuminating lamps are damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
► Eliminate the dust on the back of the unit at least once in the year to
avoid hazard by fire, as well as increased energy consumption.
Safety information
7

Publicité

loading