GreenWorks G24LT25 Manuel Opérateur page 11

Use only with the nylon cutting line of 1.65 mm
diameter.
1. Cut a piece of cutting line approximately 3 m
long.
2. Bend one end of the line approx. 6 mm.
3. Insert the line into the anchor hole of the spool.
4. Wind the cutting line around the spool tightly in
the indicated direction.
IMPORTANT
Failure to wind the line in the indicated direction will
cause the trimmer head to operate incorrectly.
5. Put the cutting line in the line slot.
6. Do not wind the cutting line beyond the edge of
the spool.
7 TRANSPORTATION AND STORAGE
7.1 MOVE THE MACHINE
When you move the machine, you must:
• Wear gloves.
• Stop the machine.
• Remove the battery pack.
• Assemble the blade guard.
7.2 STORE THE MACHINE
• Remove the battery pack from the machine and
charge it.
• Make sure that children cannot come near the
machine.
• Keep the machine away from corrosive agents such
as garden chemicals and de-icing salts.
• Secure the machine during transportation to prevent
damage or injury. Clean and examine the machine
for any damage.
English
NOTE
7
EN