Domo DO-261A Mode D'emploi page 32

DO-261A
Cleaning the Air Filter
Switch the appliance off and unscrew the air filter's locking system by a half turn
upwards. This is located at the back of the appliance. To remove the air filter, press
upwards. Wash the filter in a mixture of soap and lukewarm water and allow it to dry
carefully before putting it back into place. If the appliance is located/placed in a very
dusty place it should be cleaned every two weeks.
Not Using the Appliance for an Extended Period
Remove the rubber plug from the drainage openings to remove
remaining water.
Allow the ventilator to run own its own for another day in order to make sure the
appliance is thoroughly dry inside and to prevent mould forming.
Switch the appliance off and remove the plug from the electric socket. Remove the
batteries from the remote control. Clean the air filter, dry it and then put it back.
Disconnect the air pipe and carefully close the opening.
ERROR MESSAGES
The appliance does not click on
The appliance works only for a
short while
The appliance works but
does not cool off/down in
COOLING mode
The appliance is not plugged in properly to the
socket.
The fuse in the fuse box is blown
The batteries in the remote control have run out
Always wait for steeds 3 minutes before you
restart the appliance
The selected temperature is approaching the room
temperature
Select a lower temperature or wait until the
appliance automatically switches on again
The air outlet is blocked
A window or door is open
There is a heater or heating element switched on
The air filter is dirty
Air or inlet/outlet is blocked
32