Morphy Richards VapoCare Mode D'emploi page 8

Troubleshooting
When I press the precision vapour trigger (2), no
vapour sprays from the vapour nozzle (1) but the
nozzle flashes and beeps.
When I press the precision vapour trigger (2) the
nozzle light turns on, I can hear the pump but no
water sprays out of the vapour nozzle (1).
There is a loud noise when I press the precision
vapour trigger (2).
8
Solution
• Check the water tank (6) is full and the base (14) is
resting on a level surface. The water may be below the
minimum level.
• If the water tank is full, check the water tank is correctly
located in the base.
Solution
• There may be a blockage in the vapour system. You need
to remove the vapour nozzle (1):
1 Turn the clear nozzle cover anti-clockwise until it is
released.
2 Unscrew the nozzle by rotating it anti-clockwise.
3 Tap the vapour nozzle gently on a hard surface to
remove any loose debris.
4 Plug the product in and press the precision vapour
trigger (2) for around 30 seconds to remove any
blockages from the system. Do this over a sink or
suitable container.
NOTE: Water will jet out under high pressure.
Reassemble the vapour nozzle and nozzle cover; this is
a reversal of the removal procedure. Press the precision
vapour mist trigger to test the system. If the system is
still blocked, repeat the process or call our helpline for
further instructions.
1
Solution
• This is normal when you operate the product for the first
time as the vapour system is being primed.
• If you hear a loud noise but no vapour is sprayed, check
for blockages as above.
2