Publicité
Les langues disponibles
Les langues disponibles
9. Light Kit Assembly.
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws.
Align slotted holes in fitter plate with loosened
screws in motor plate, allowing molex
connectors to come through center hole in
fitter plate. Twist fitter plate to lock. Re-insert
screw that was previously removed and
securely tighten all 3 screws with a Phillips
screwdriver.
Remove 3 screws from underside of fitter plate.
Connect WHITE wire from motor housing to
WHITE wire from the LED light kit and BLUE
(or BLACK) wire from motor housing to BLUE
wire from LED light kit. Make sure molex
connections snap together completely.
Carefully arrange wiring within the back of
LED light kit. Align holes in LED light kit with
holes in fitter plate. Re-insert screws
previously removed and securely tighten all
3 screws with a Phillips screwdriver.
Locate slots on shade and align with nodules
on inside of fitter plate.
shade and turn
to the RIGHT (clockwise)
slides completely into place.
Gently push up on
until it
motor plate
molex connections
LED light kit
screw
nodules
slots
page 9
motor
housing
fitter plate
screw
motor
housing
fitter plate
molex connections
motor
housing
shade
Publicité
