Craftmade Champion Guide D'installation page 8

7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw that was
removed, and then tighten both screws securely.
Slide canopy cover up to canopy, aligning nodules in
canopy cover with notches in center hole on bottom of
canopy. Turn canopy cover to the right (clockwise) until
it stops.
8. Blade Assembly.
WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If overtightened,
blades may crack and break.
Tip: Break apart fiber washers from set and
then place one washer on each blade
screw prior to installing blades.
Locate 18 blade attachment screws and
washers in hardware pack. Slide a blade
through one of the narrow, rectangular
openings on the center band, aligning
holes in blade with holes in blade arm
located on the underside of the center
band --refer to drawing at right. Insert 2
blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat procedure for the remaining
blades.
Note: Tighten blade arm screws twice a
year.
screw
(view from underside)
blade arm
page 8
hanging bracket
canopy
canopy cover
blade
blade attachment
screws and washers