Publicité
Les langues disponibles
Les langues disponibles
5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Remove pin
and clip. Lower hanging ball and remove stop
pin and then slide hanging ball off of the
downrod. [Refer to diagram 1.]
Loosen yoke set screws and nuts at top of motor
housing. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod. [Refer to
diagram 2.]
Determine the length of downrod you wish to
use. Thread safety cable and electrical wires
through threaded end of downrod and pull extra
wire slack from the upper end of the downrod.
[Refer to diagram 2.]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--make sure wires do not get twisted.
Re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely. [Refer to diagram 2.]
Slide yoke cover, canopy cover and canopy over
downrod. [Refer to diagram 3.]
Thread safety cable and wires through hanging
ball and then slide hanging ball over downrod --
the top of the downrod should be noted as
having a set screw hole; use this hole when
setting the set screw. Insert stop pin into top of
downrod and raise hanging ball. Be sure stop pin
aligns with slots on the inside of the hanging
ball. Tighten set screw securely. [Refer to diagram
4.]
WARNING: Failure to tighten set screw (on
hanging ball) completely could result in the fan
becoming loose and possibly falling.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
diagram 1
electrical wiring
downrod
clip
diagram 2
yoke
cover
diagram 3
stop pin
diagram 4
page 5
stop pin
hanging ball
clip
pin
safety cable
yoke set screw
and nut
downrod
canopy
canopy cover
set screw hole
hanging ball
pin
motor
housing
motor
housing
Publicité
