Hitachi N 5010A Manuel D'instructions Et De Sécurité page 15

● When working close to an edge of a
workpiece or at steep angles, or driving
fasteners into thin workpiece use care to
minimize chipping, splitting or splintering, or
free fl ight, ricochet or piercing of fasteners,
which may cause injury.
● Never drive staples from both sides of a wall
at the same time. Staples can be driven into
and through the wall and hit a person on the
opposite side.
● Never use Stapler which is defective or
operating abnormally.
● Do not use Stapler as hammer.
● Disconnect air hose from Stapler when:
1) it is not in use;
2) leaving work area;
3) elevating, lowering or otherwise moving it
to another location;
4) handing it to another person;
5) performing any maintenance or repairs;
6) clearing a jam;
7) Stapler is outside of the operator's
supervision or control;
8) removing staples from the magazine; and
9) adjusting stapling depth;
This Hitachi Stapler has a STANDARD CONTACT
TRIP MECHANISM (Bounce Fire). An OPTIONAL
SEQUENTIAL TRIP MECHANISM kit (SINGLE SHOT) is
available as order part number 876762.
THE STANDARD CONTACT TRIP MECHANISM (Bounce
Fire) is for use where rapid fastener placement is desired
and must be operated in accordance with the following
"Methods of Operation".
METHODS OF OPERATION
This Stapler is equipped with the push lever and does
not operate unless the push lever is depressed (upward
position).
There are two methods of operation to drive staples with
this Stapler.
They are:
1. Intermittent operation (Trigger fi re):
2. Continuous operation (Push lever fi re):
(1) Intermittent operation (Trigger fi re)
1 Position the staple outlet on the workpiece with
fi nger off the trigger.
2 Depress the push lever fi rmly until it is completely
depressed.
3 Pull the trigger to drive a staple.
4 Remove fi nger from the trigger.
To drive another staple, move the Stapler along the
workpiece and repeat this procedure.
2
Push lever
(2) Continuous operation (Push lever fi re)
● To avoid double fi ring or accidental fi ring due
to recoil.
1) Do not press the stapler against the
workpiece with excessive force.
2) Separate the stapler from the workpiece
as it recoils after stapling.
1 Pull the trigger with the Stapler off the workpiece.
2 Depress the push lever against the workpiece to
drive a staple.
3 Move the Stapler along the workpiece with a
bouncing motion.
Each depression of the push lever will drive a
staple.
As soon as the desired number of staples have been
driven, remove fi nger from the trigger.
Previously pull the trigger
3
Push lever
English
Trigger
3
WARNING
1
15