Domo DO919RKG Mode D'emploi page 35

PARTS
1. Freezer
2. Thermostat and light
3. Shelves
4. Cover for vegetable container
5. Vegetable container
6. Door shelves
BEFORE THE FIRST USE
· Avoid placing the cabinet in a narrow recess or near any leave source, direct sunlight, or
moisture.
· Let air circulate freely around the cabinet. Keep the rear of the refrigerator 13 cm away
from the wall.
· Select a place with a strong, level floor. One can level the appliance using adjustable legs.
The adjustable legs can be adjusting by screwing them in or out of the appliance.
· Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources
nearby will cause higher electricity consumption.
· Avoid very moist places. Too much moisture in the air will cause frost to from very quickly
on the evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that the voltage stated
on the rating label of your appliance corresponds to the voltage in your home. A different
voltage could damage the appliance.
· The appliance must be grounded. The manufacturer is not responsible for damages that
may occur as a result of usage without grounding.
· For uneven surfaces, front feet can be aligned.
· After installation, leave the freezer for 12 hours before turning it on. This way the
refrigerant can settle.
TEMPERATURE CONTROL
· The internal temperature can be controlled by the thermostat, which can be set to 6
different positions. 1 is the warmest setting and 5 is the coldest. To turn off the appliance,
set the temperature control to '0'.
· Operating time and temperature are affected by where the freezer is used, the number of
times the door is opened and the temperature of the room it is in.
www.domo-elektro.be
1
2
3
4
5
DO919RKG - DO919RKC - DO919RKZ
6
35