Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Prepare Cooktop for Installation
WARNING
Excessive Weight Hazard
Use two or more people to move and install cooktop.
Failure to do so can result in back or other injury.
Decide on the final location for the cooktop. Avoid drilling into or
severing existing wiring during installation.
1. Using 2 or more people, place the cooktop upside down
on a covered surface using the foam end posts from the
packaging. Make sure that the knobs are not resting on the
foam.
2. (Optional) Remove foam strip roll from the package
containing literature. The roll contains four 1/4" (6.4 mm)
strips of foam. Remove one strip at a time and apply foam
strip adhesive-side down around bottom of the cooktop
glass.
NOTE: The foam strip helps avoid damage to the underside
of the cooktop glass from debris and helps the cooktop sit
flat on uneven counters.
A. Cooktop base
B. 1/4" (6.4 mm) Foam strip
C. Cooktop
INSTALLATION INSTRUCTIONS
A
B
C
Install Cooktop
Style 1: Cooktop over undercounter built-in oven
IMPORTANT: Clamping brackets should not be used.
1. Using 2 or more people, place cooktop right side up into
the cutout.
NOTE: Make sure that the front edge of the cooktop is
parallel to the front edge of the countertop. If repositioning
is needed, lift entire cooktop up from cutout to avoid
scratching the countertop.
Style 2: Cooktop over cabinets
1. Determine whether your cabinet construction provides
clearance for installing clamping brackets at cooktop
base ends.
24" (60.9 cm), 30" (76.2 cm) and 36" (91.4 cm) traditional
models
A. Cooktop base bottom
B. Attachment screw
C. Clamping bracket
2. The clamping brackets can be installed before or after the
cooktop is placed into the cutout. Complete the following
steps for the option you choose.
A
B
C
5
Publicité
Table des Matières
