Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
WARNING:
other parts may create a hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified service technician.
WARNING:
from the product when cleaning or performing any maintenance.
CLEANING
Use a soft brush to remove debris from all air intakes and cutting blade.
To remove pitch and other sticky residue, spray the blades with resin solvent. Run
the motor briefly so that the solvent is event distributed, then wipe the surface
with a dry cloth.
WARNING:
when cleaning plastic parts. Most plastics are susceptible to damage from various
types of commercial solvents. Use clean cloths to remove dirt, dust, oil, grease, etc.
SHARPENING THE CUTTING
BLADE
1. Start and stop your hedge trimmer
until the cutter blade and the guard are
slightly offset, as shown in Fig. 7. This
will allow clearance for the file between
cutter teeth and guard teeth.
2. Remove the battery pack from your
hedge trimmer.
3. Clamp the blade assembly in a vise and file the exposed cutting surface of each
blade tooth. Remove as little material as possible. Be sure to retain the original angle
of each tooth when filing.
4. Remove the hedge trimmer from the vise; reinstall the battery, restart it and then
stop it to expose the unsharpened edges of the blade teeth.
5. Remove the battery pack and repeat the sharpening procedure above.
24
56V LITHIUM-ION CORDLESS HEDGE TRIMMER — HT2600/HT2600-FC
When servicing, only use identical replacement parts. Use of any
To avoid serious personal injury, always remove the battery pack
Never use water for cleaning your trimmer. Avoid using solvents
7
Cutter Tooth
Cutting Surface
Guard Tooth
Publicité
