Domo DO91333C Mode D'emploi page 57

9. Loosen screw ③ and take down the stop block ② and door stopper ① from the bottom right side.
Install the replacement door stopper, that can be found in the accessory bag provided, and the stop
block ② on the left side with the screw ③.
10. Move the cover caps from one side to the other in the middle of the appliance.
11. Carefully tip the appliance backward. Remove the levelling feet (②, ③ & ⑤). Remove the bottom
hinge ① by unscrewing the screws. After removing foot ③, remove the hinge pin from the plate and
turn it 180°. Remount the pin in the hinge so that it protrudes upwards when the hinge is turned.
Then mount foot ③ again.
! Attention: the inclination of the refrigerator must be less than 45° so that the compressor oil does not
enter the cooling circuit. If you do shut down the unit completely, wait 8 hours before turning it back on.
www.domo-elektro.be
57
DO91333C