Domo DO91333C Mode D'emploi page 55

· Select a place with a strong, level floor.
· Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will
cause higher electricity consumption.
· Avoid very moist places. Too much moisture in the air will cause frost to form very quickly on the
evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that the voltage stated on the rating
label of your appliance corresponds to the voltage in your home. A different voltage could damage the
appliance.
· After installation, leave the fridge-freezer for 24 hours before turning it on. This way the refrigerant
can settle.
· Allow the appliance to run empty for 12 hours so the compartment can cool to the appropriate
temperature.
· One can level the appliance using the adjustable legs. The adjustable legs can be adjusted by screwing
them in or out of the appliance.
· The climate class indicates the minimum and maximum ambient temperature for the proper operation
of an appliance. You can find the climate class on the type plate on the back of the appliance.
· SN: Subnormal: ambient temperature between 10°C and 32°C
· N: Normal: ambient temperature between 16°C and 32°C
· ST: Subtropical: ambient temperature between 16°C and 38°C
· T: Tropical: ambient temperature between 16°C and 43°C
DOOR CONVERSION
If you need to hinge your door on the opposite side, it is recommended that you call your local authorised
service agent to make this conversion or ask a technician. Before you reverse the door, you should ensure
the appliance is unplugged and empty. After reversing the door, leave the appliance alone for 8 hours
before switching it on. This allows the coolant to set.
It is recommended to use a crosshead screwdriver, a flathead screw-
driver, a socket wrench (8 mm) and a wrench (8 mm) (not supplied).
1. Loosen the screw of the hinge cover plate and remove the plate.
www.domo-elektro.be
Lift Lower
16
55
DO91333C