Lotus ACC060E Instructions De Montage page 3

EN
INSTRUCTIONS – AIR CONDENSATION HOOD (models ACC060 – ACC061 – ACC106)
Important !
Assembly and connection to be carried out by trained staff
-
Before assembling the hood, disconnect the oven
-
1) Place the hood over the oven, as indicated in the drawing;
2) Use the 2 screws (2) to fix the bracket (1) on the rear corner of the oven and use the crew
(3) to fix the hood. Repeat the same operation with the other bracket to fix it on the other
rear corner of the oven;
3) Connect the rubber pipe (4) to the condensation drain of the hood and lead it to the
wall/floor outlet used for the oven. While the oven is working, some condensation water,
collected by the hood, will go out from this pipe.
4) Connect the hood with the power cable (5)
5) Switch on the hood using the switch (6) located on its left side (front view)
Once the hood has been installed, re-connect the oven to its power supply.
Important! The hood must always be on while the oven is working. Do not use the oven if
the hood is switched off. This may cause some water leakage from the hood, compromising
functioning of both appliances, oven and hood.
It is absolutely normal if the hood is not able to suction all the steam coming out from the door
and that some steam will be lost in the environment. Open the door slightly (some
centimetres), before opening it completely. This will improve the performance of steam
suction.
3