Publicité
Les langues disponibles
Les langues disponibles
13
Operation Instructions
1. The sequence of operation for the motor pull/chain switch is
OFF-HI-MED-LOW.
2. Push the slide switch RIGHT for FORWARD, and LEFT for
REVERSE action of the blades.
3. The pull chain switch for the lighting is two positions - ON/OFF.
4. The pull chain switch for the uplighting is on/off.
Uplighting takes 4-7W Candelabra bulbs (not included).
Light Pull Chain
CAUTION
Even if your fan is mounted with the blades more than 7 feet from the floor,
be careful to avoid placing your raised arms or any object in the path of the
blades.
NOTE: Sentry
Motor Pull Chain
Slide Switch
14
Electrical Connections
Connect black and blue (if provided) fan wires to black outlet wire.
Connect white fan wire to white outlet wire and green grounding lead
wire from the grounding conductor to the supply circuit (see figure A).
Use wire connectors provided with your fan. No loose strands or loose
connections should be present. After wires have been connected, they
must be spread apart so the green and white are on one side of the outlet
box and the black and blue are on the other side. Turn
splices upward and carefully
push all wiring into outlet
Black
box. For optional wall
control see Figure B or
Figure C for alternate wiring.
When wall switches are employed,
switches should be UL listed
for use with ceiling fan.
NOTE: Make sure fan on/off switch
is always at "high speed" location if
your fan is controlled by additional
wall switch.
Ground
White
Blue
Black
Figure A
Optional Light
Green
White
Publicité
