Publicité
Les langues disponibles
Les langues disponibles
6
Position downrod so the hole in the downrod aligns with the hole in the
coupling on the motor. Insert safety bolt (S7) through coupling and
downrod and attach nut. Tighten firmly. Tighten set screw "A" against
downrod. Place flange cover (#4) over downrod assembly until it covers
flange. Place canopy (3) over downrod (#2). Replace hanging ball, insert
hanging pin through downrod and tighten set screw "C" in hanging ball
into downrod.
Threaded Set
Screw Hole
Ground
Hanging
Wire
Pin
Ball
Screw
Hanging
Ball
Safety Bolt
and Nut
WARNING: Failure to
completely tighten
downrod as described in
steps 5 & 6 above could
result in the fan loosening
and possibly falling.
Step 6
Set Screw (C)
Downrod (2)
Canopy (3)
Flange Cover (#4)
Set Screw (A)
Motor Housing (5)
7
For added security, attach safety cable from fan unit to "J" hook (S10) in
outlet box. Secure by looping zip tie (S11) through safety cable and "J"
hook. Tighten zip tie securely. Lift fan onto the mounting bracket (#1).
Turn housing until hanging ball seats itself into ball socket (listen for
click).
OUTLET BOX
Green Ground Wire
NOTE: Parts furnished will allow
"J" Hook (S10)
you to install your fan at up to a
35° angle. Angles greater than 35°
will require a 45° angle adapter (see
dealer). NOTE: J Hook
installation is a Canadian
requirement only.
WARNING: To reduce the risk of fire, electric shock or personal injury, mount
so outlet box marked "acceptable for fan support" and use mounting screws
provided with the outlet box. Most outlet boxes commonly used for the support
of lighting fixtures are not acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
Step 7
Support Beam
"J" Hook (S10)
Outlet Box (A)
Ceiling
Mounting Bracket (#1)
Zip Tie (S11)
Safety Cable
Publicité
