Télécharger Imprimer la page

Aurlane CAB240 Mode D'emploi page 24

110x80x215-230cm

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
EN
Garantee
AURLANE products are guaranteed for 2 years, spare parts only. As the labor is not carried out by us, no labor
guarantee will be applied by AURLANE. In the event of a proven manufacturing defect or breakage of an element
of the cabin, these elements can be ordered from the distributor who sold this cabin, however in no case will the
labor relating to the replacement of the part be taken into account charge by AURLANE.
The installation of this shower enclosure needs to be carried out according to the rules of the art. Our company
declines all responsibility and reserves the right not to ensure its guarantee in the event that this product is not
installed by qualified personnel. In the event of a request for an item under warranty, it is imperative to provide
the purchase invoice for the product.
The glazed elements are wrapped in transparent film to allow the condition of these elements to be checked
during purchase. No replacement of these elements will be supported by AURLANE in the event that a breakage
is reported after the removal of the packages in store or during delivery the breakage of the glass is not covered
by guarantee if it is not clearly indicated on the delivery note.
It is essential to check the condition of each item when unpacking. No complaint relating to the quality of the
product will be taken into account after a period of 14 days after the purchase of the product. Remember to
keep the manual as well as an official purchase document (invoice, receipt) for any complaint or request for spare
parts.
Non-application of the guarantee: incorrect assembly, unsuitable hot water production, lack of maintenance,
limestone, accident or impact, use of abrasive or corrosive products, modification of the coating of the original
surface. Electrical and sanitary installation of the home not complying with regulatory standards.
Failure to follow instructions for use and installation methods will void the warranty.
Installation
The assembly must be carried out with at least two people, so as to be able to maintain and fix certain elements.
It is imperative not to embed the cabin in the wall and the floor. The back of a shower cubicle must always remain
accessible in the event of the need to work on the connections. Also follow the pre-installation instructions on
the next page.
The glass elements are made of tempered glass for standards and safety reasons. As tempered glass is designed
to explode into (non-sharp) pieces on impact, these items should be handled with extreme care. For this same
reason, it is essential not to force the tightening of the accessories to be fixed on the glazed elements (door
handles, shelves, shower holder, towel holder, etc.). You can protect the glass elements by laying them on
blankets or pieces of carpet. Never place a glass part on an angle.
The pressure of the water supplied must be between 2 and 4 bars. Exceeding these limits influences the normal
use of the product. If the water pressure is very low, it is advisable to install a pressure pump, contact your
sanitary equipment distributor for this. If the pressure is too high, the cab piping may leak.
In order to facilitate the final assembly of the cabin, certain components such as nozzles or valves can be pre-
assembled on the product. However, it is imperative to check the tightening of the elements and to carry out a
water test before the final installation of the cabin.
24

Publicité

loading