AFG PRO 7.2 AT Manuel Du Propriétaire page 9

TOOLS INCLUDED:
6 mm T-Wrench
F
5 mm L-Wrench
F
PARTS INCLUDED:
1 Console Assembly
F
2 Console Masts
F
2 Console Mast Boots
F
1 Hardware Kit
F
1 Safety Key
F
1 Audio Adapter Cable
F
1 Bottle of Silicone Lubricant
F
(for 2 applications)
1 Crossbar
F
1 Power Cord
F
2 Console Joint Covers
F
NEED HELP?
If you have questions or if there
are any missing parts, contact
Customer Tech Support. Contact
information is located on the
back panel of this manual.
PRE ASSEMBLY
UNPACKING
Place the treadmill carton on a level flat surface. It is recommended that you place a
protective covering on your floor. Take CAUTION when handling and transporting this unit.
Never open box when it is on its side. Once the banding straps have been removed, do not
lift or transport this unit unless it is fully assembled and in the upright folded position, with
the lock latch secure. Unpack and assemble the unit where it will be used. The enclosed
treadmill is equipped with high-pressure shocks and may spring open if mishandled. Never
grab hold of any portion of the incline frame and attempt to lift or move the treadmill.
WARNING
DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill from
packaging until specified to do so in the assembly instructions. You may remove the
plastic wrap from console masts.
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and partially
threaded in before completely tightening any ONE bolt.
NOTE: A light application of grease may aid in the installation of hardware. Any grease, such
as lithium bike grease is recommended.
9